DA Handlebar Switch Black or Chrome
DIRTY AIR Handlebar Grip Switch. New steel housing with waterproof push buttons, select finish options. Fits left or right side. Each push button can control either the UP or the DOWN function for your air system. A rear system would need one unit, a front+rear system would require (2) complete handlebar grip switch units, one to mount on the left and one to mount on the right. This switch housing replaces the clamp used to secure the clutch assembly on the left side or master cylinder on the right side.
*Fits 1996-Later Harley-Davidson hand controls. Fits any diameter handlebar, as long as you are using Harley-Davidson hand controls, and not an aftermarket clutch/master cylinder assembly*
*WILL NOT FIT 2015-LATER ROAD GLIDE FACTORY HANDLEBARS (Due to factory anti-rotation pin – contact us for options and details, bars can be modified or some aftermarket bars will allow fitment)*
Please note the push buttons maximum current allowance is 1 amp. Any component drawing over 1 amp requires a relay. Relay is not needed when using the Xotic Customs Taildragger and Tank kit.
*Handlebar switch housings do not have a “notch” for wires to exit. Handlebars that will not be wired internally should have dimples on the bottom side to allow wires the exit the handlebar switch housing without being pinched. If you do not plan to wire the switch wires internally, make sure your handlebars are dimpled for external wiring*
You have a choice of all chrome or all black. These have a limited one year warranty which is fulfilled by Dirty Works-KC
$150.00